phase to ground voltage calculator
Calculate phase-to-ground voltage in single-phase and three-phase systems. Essential for power distribution, grounding checks, and electrical safety.
3 phase voltage to ground
In three-phase circuits, to obtain phase-to-ground voltage from line-to-line voltage, divide that voltage by sqrt{3}. In single-phase circuits use the line-to-neutral voltage.
Formula & Table Summary:
- Single Phase: VPG = VLN
- Three Phase: VPG = VLL / √3
electrical grounding voltage
A Phase to Ground Voltage Calculator can be used to check the voltage between a live conductor and ground on a single or three-phase circuit as a safety and equipment verification mechanism.The calculator can be applied by engineers, electricians, and students troubleshooting a power distribution network on the grounding, motors, and grounding checks. Just key the type of system and voltage and you will get the results immediately.
ground fault voltage
| System Type | V_LL (V) | V_LN (V) | V_PG (V) |
|---|---|---|---|
| Single-phase | — | 120 | 120 |
| Three-phase | 400 | — | 230 |
Frequently Asked Questions - phase to ground voltage calculator:
What is phase-to-ground voltage?
It is the voltage measured between a live phase conductor and ground (earth).
How to calculate phase-to-ground voltage in 3-phase systems?
Divide line-to-line voltage by √3.
Is phase-to-ground voltage the same as line-to-neutral?
Yes, in balanced systems.
Why is phase-to-ground voltage important?
It helps ensure safety, prevent overvoltage, and match equipment ratings.
What is the phase-to-ground voltage of 400V 3-phase?
Approximately 230V.
What happens if phase-to-ground voltage is too high?
It may indicate a fault or incorrect grounding.
Can phase-to-ground voltage be zero?
Only in a fault or open circuit condition.
What is V_LL in the formula?
V_LL is line-to-line voltage.
Why divide by √3 in 3-phase?
Because the phase voltage is the projection of line voltage in a balanced system.
Does grounding type affect voltage?
Yes, especially in ungrounded or high-resistance grounded systems.
Related Posts
step down voltage calculator
Easily calculate output voltage when stepping down AC or DC using transformers or voltage dividers. Ideal for electronics, power supply design, and safety.
No-load voltage calculator
Calculate the no-load (open circuit) voltage of generators, transformers, or other sources using EMF equations, winding data, and test parameters.
Amps to VA Calculator
Instantly convert electrical current in amps to apparent power in volt-amperes (VA) using voltage and current. Ideal for AC circuit power calculations.
kVA to VA Calculator
Use this simple kVA to VA calculator to convert kilovolt-amps to volt-amps. Just enter the kVA value to get its equivalent in VA. Fast, accurate, and ideal for electrical systems.
sine wave voltage calculator
Calculate peak, RMS, and average voltages of sine waves from any input voltage parameter. Essential for AC circuit analysis and electrical engineering.
dbm to rms voltage calculator
Convert dBm power levels to RMS voltage easily using impedance and power formulas. Ideal for RF engineers and audio signal analysis.